Using the Auto-Adjustment Function | HP LP2465, LP2065 20' specification

Using the Auto-Adjustment Function

You can optimize the screen performance for the VGA (analog) input by using the -/Autobutton on the monitor and the auto-adjustment pattern software utility on the CD provided.

Do not use this procedure if the monitor is using a DVI input. If the monitor is using a VGA (analog) input, this procedure can correct the following image quality conditions:

●Fuzzy or unclear focus

●Ghosting, streaking or shadowing effects

●Faint vertical bars

●Thin, horizontal scrolling lines

●An off-center picture

To use the auto-adjustment feature:

1.Allow the monitor to warm up for 20 minutes before adjusting.

2.Press the -/Autobutton on the monitor front panel.

●You can also press the Menu/Select button, then select Auto-Adjustmentfrom the OSD Main Menu. Refer to Adjusting the Monitor Settings on page 21 in this chapter.

●If the result is not satisfactory, continue with the procedure.

3.Insert the CD in the disc drive. The CD menu is displayed.

4.Select Open Auto-Adjustment Software . The setup test pattern is displayed.

5.Press the -/Autobutton on the monitor front panel to produce a stable, centered image.

6.Press the ESC key or any other key on the keyboard to exit the test pattern.

ENWW	Using the Auto-Adjustment Function 19

Image 27

HP LP2465, LP2065 20' manual Using the Auto-Adjustment Function

Contents

HP LP1965 19, LP2065 20, and LP2465 24 LCD Monitors Page About This Guide Iv About This Guide Table of contents Appendix a Troubleshooting Appendix D LCD Monitor Quality and Pixel Policy Viii HP LP1965, LP2065, and LP2465 Models Product Features Enww Important Safety Information Safety and Maintenance Guidelines Maintenance Guidelines Cleaning the MonitorShipping the Monitor Installing the Monitor Pedestal Base Setting Up the Monitor Component Function Rear Components 3Connecting the DVI-I to VGA Signal Cable Selecting the Signal Connectors and Cables 6Connecting the Power Cable Setting Up the Monitor Connecting the Monitor Adjusting the Monitor Enww Turning on the Monitor 12Connecting USB Devices Setting Up the Monitor Connecting USB Devices Removing the Monitor Pedestal Base Using the Accessory Rails Mounting the Monitor 17Inserting the Monitor Panel into the Quick Release Locating the Rating Labels 18Locating the Rating Labels Setting Up the Monitor Image Color Matching File Operating the MonitorSoftware and Utilities Information File Installing the .INF and .ICM Files Installing from the CDDownloading from the Worldwide Web Using the Auto-Adjustment Function 1Monitor Front Panel Controls Front Panel Controls Using the On-Screen Display Menu Adjusting the Monitor Settings OSD Menu 2OSD Menu DVI-I#1 Optimizing Digital Conversion Using the HP Display Assistant Utility Identifying Monitor Conditions Sleep Timer Mode Installing the HP Display LiteSaver Software 3HP Display LiteSaver Configuration OptionsHP Display LiteSaver SRGB Support Changing the Color Temperature SRGB Support Solving Common Problems Troubleshooting Problem Possible Cause Using the Worldwide Web Preparing to Call Technical Support Technical Specifications Table B-1LP1965 Model SpecificationsLP1965 Model LP2065 Model Table B-2LP2065 Model Specifications LP2465 Model Table B-3LP2465 Model Specifications Recognizing Preset Display Resolutions Table B-4LP1965 Model Factory Preset ModesTable B-5LP2065 Model Factory Preset Modes Table B-6LP2465 Model Factory Preset Modes Entering User Modes Energy Saver Feature Cables Agency Regulatory NoticesFederal Communications Commission Notice Modifications Canadian Notice Avis CanadienEuropean Union Regulatory Notice Japanese Notice Korean Notice Power Cord Set Requirements Japanese Power Cord RequirementsGerman Ergonomics Notice Materials Disposal Product Environmental Notices 11363-2006 LCD Monitor Quality and Pixel Policy