HP M1530 manual Network Setup menu

Menu item	Sub-menu item	Description
Archive Print	On	When printing pages that will be stored for a long time,
	Off	this option sets the product to a mode that reduces
		toner smearing and dusting.
		The default setting is Off.
Firmware Date		Displays the current firmware date code.
Restore Defaults		Sets all settings to the factory default values.

Network Setup menu

Menu item	Sub-menu item	Description
TCP/IP Config	Automatic	Automatic automatically configures all the TCP/IP settings via
	Manual	DHCP, BootP or AutoIP.
		Manual requires you to manually configure the IP address, subnet
		mask, and default gateway.
		The control panel prompts you to specify values for each address
		section. Use the arrow buttons to increase or decrease the value.
		Press the OK button to accept the value and move the cursor to
		the next field.
		As each address is completed, the product prompts for address
		confirmation before moving to the next one. After all three
		addresses are set, the product automatically restarts.
Auto Crossover	On	Sets the auto crossover function.
	Off
Network Services	IPv4	Sets whether the product will use either IPv4 or IPv6 protocol.
	IPv6
Show IP Address	Yes	Sets whether the product displays the IP address on the control
	No	panel.
Link Speed	Automatic	Sets the link speed manually if needed.
	10T Full	After setting the link speed, the product automatically restarts.
	10T Half
	100TX Full
	100TX Half
Restore Defaults		Resets all network configurations to their factory defaults.

ENWW Setup menu 17