Chapter 1
Set the region
Along with the Language setting, the Region setting determines the default date format and the format of the video signal for displaying camera images on a television when connected through an optional
HP Photosmart Premium dock or wireless dock base (see Using the Setup Menu on page 31).
Use 
to choose the region you want, then press
.
Set the date and time
1.Use 
to adjust the highlighted value.
2.Use 
to move to the other selections and repeat Step 1 until the date and time are set correctly.
3.Press 
when the date, time, and format settings
are correct, then press 
again to confirm.
To change the date and time later, use the Setup
Menu (see Using the Setup Menu on page 31).
Install and format an optional memory card
1.Turn off the camera and
open the Battery/Memory card door.
2. Insert the memory card in the smaller slot as shown. Make sure the memory card snaps into place.
3. Close the Battery/Memory card door and turn on the camera.
Always format memory cards before first use.
1.With the camera turned on, press 
until 
appears briefly in the upper right corner of the Image Display. This indicates you are in Playback.
2.Press 
.
3.Use 
to select Format Card, then press 
.
4.Use 
to select Yes, then press 
to format the card.
Note Once you install a memory card, all new images and video clips are stored
on the card, rather than in internal memory. To use internal memory and view images stored there, remove the memory card. To transfer images from internal memory to an optional memory card, see Move Images to Card under Using the Design Gallery Menu on page 22.
For information about supported memory cards, see Storage on page 43.
Install the software
The HP Photosmart Software provides features for transferring images and video clips to your computer, as well as features for modifying stored images (remove red eyes,
8
