✎Be sure to place the rubber boot cover over the DFP (digital) connector on the projector when it is not in use to prevent electrostatic discharges from damaging the connector.

Powering On the Projector

Follow these instructions to power on the projector:

1.Ensure that the power cord and signal cable are securely connected.

✎Make sure the projector is perpendicular to the screen.

2.Remove the lens cap 1 by pulling it straight out.

3.Turn on the Main power switch 2 on the back of the projector and allow the projector to warm up for 1-2 minutes.

✎When the projector has warmed up, the Compaq startup screen will display and the LED on the Standby button 3 will turn green. When the startup screen disappears, the video from the attached computer will display. If there is no incoming video, the “Check Video Cable ” message will display on the projection screen.

MP1600 Microportable Projector 1-9