HP mp2210, mp2215 manual Installing Permanently, Installing the projector, Choosing cables

5 Installing Permanently

Installing the projector

Choosing cables

If you are permanently installing the projector or using it with long cables, consider the following suggestions when planning the installation:

•Use high-quality cables. Use only video cables that are made with 75-ohm coaxial cable and connectors. For high-resolution video, use low-loss video cables.

•Minimize cable length as much as possible. For video cables longer than 6 m (20 ft), use low-loss coaxial cables.

•Do not run audio or video cables next to power or network cables. If they must cross, cross them at 90 degrees.

•If you are installing cables in walls, use cables with necessary approvals, such as Underwriters Laboratories (UL) approval.

•If you are running cables above a dropped ceiling, you must use plenum-rated cables if the space above the ceiling is open to the space above other rooms. You must use plenum- rated cables if you are running cables in a duct.

•Before installing cables permanently, check the setup with the final cables in the open.

Installing on a table

This installation is covered in detail in Chapter 1. See “Setting up the projector” on page 13 for more information.

Installing the projector 47