11
∙CNT DOTS: Displays the number of dots in a message and the volume of ink needed for each printing.
∙SEL NOZZL: This setting controls what channels are used to print.
oAUTO: (Recommended) the QM2 selects the best nozzle configuration based on operating conditions. (300 DPI)
oEVEN: Prints using the even channels. (300 DPI) o ODD: Prints using the odd channels. (300 DPI) o BOTH: Prints using both channels. (600 DPI)
∙RS485: This submenu configures the QM2 communications. Parameters in this menu should only be adjusted under the advice of MSSC, LLC.
∙DRV PULSE: This menu controls the print head operating parameters. Parameters in this menu should only be adjusted under the advice of MSSC, LLC.
∙SENSR DELAY: This setting allows for an overall offset for printing. This setting offsets all messages in addition to the DELAY setting in the Parameter menu.
2
∙ GAP 2L: This setting changes the gap between lines on the S special message function. The value can be set from 0 to 90%.
Serial Numbers
The serial number setup menu can be accessed from the main screen by pressing the S/N key. This menu allows for the adjustment of how serial numbers are printed.
∙NEXT S/N: Sets the next serial number to be printed. To change, enter the new number using the keypad.
∙RESET: Resets the NEXT S/N value to the value in INITIAL. To use, press ← or → key to select yes and press ↵.
∙LENGTH: Sets the desired number of digits in the serial number. The maximum number of digits is 8.
∙INCREMENT: Sets the amount the serial number increases by at each sequential change.
∙INITIAL: sets the value that NEXT S/N is set to when RESET is used.
∙COUNT UP: Sets the number of times a serial number is printed before advancing to the next number.
∙COUNTING: Keeps track of how many times a repeated serial number has been printed. This value can be set to reflect the number actually printed.
NOTE: COUNTING is decreased by 1 when the serial number setup menu is accessed.MSSC, LLC Collinsville, IL USA Tel:
www.msscllc.com