HP S4000T-P8656K, S3000T-P8654W, S3000T-P8654U, S3000V-P8654S Regulatory and Safety Information

Regulatory and Safety Information

WARNING: The Compaq Presario is heavy; be sure to use ergonomically correct lifting procedures when moving the computer.

WARNING: Electrostatic discharge (ESD) can damage disk drives, add-in cards, and other components. If an ESD station is not available, wear a wrist strap attached to a metal part of the computer. Place cards on a conductive foam pad or inside the conductive wrapper they came in; do not place the cards on top of the wrapper.

WARNING: Do not operate the system with the cover removed. Always replace the cover before turning on the system.

WARNING: Please read the “Additional Safety Information” located later in this document before installing and connecting your system to the electrical power system.

WARNING: Using the wrong type of memory module could damage the system.

WARNING: Do not pull the memory module out of the socket. Use the retaining clips to eject the module.

WARNING: Do not overload the system by installing add-in cards that draw excessive current. The system is designed to provide 2 amps (average) of +5 V power for each board/card in the computer. The total +5 V current draw in a fully loaded system (one with all add-in card slots filled) must not exceed the total number of slots multiplied by 2 amps.

WARNING: Be careful of the sharp edges on the expansion slot cover.

WARNING: There is danger of an explosion if the battery is incorrectly replaced. Replace only with the same, or equivalent, type of battery. Discard used batteries according to the manufacturer’s instructions.