Removing and replacing the chassis cover

To install internal hardware, you must remove the chassis cover as shown in the following procedures.

ÅWARNING: Before removing the chassis cover, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet.

1.Remove the two screws that secure the cover to the chassis 1.

2.Slide the cover about 1/2-inch toward the back of the unit, and then lift the cover off the chassis 2.

3.Disconnect the speaker cable 3 from the system board.

Removing the chassis cover and disconnecting the speaker

To replace the chassis cover, reverse the previous procedure.

Hardware Reference Guide

www.hp.com

2-3

HP t5725 manual Removing and replacing the chassis cover