Removal and Replacement Procedures

21

3. Remove the power button/LED assembly.

To replace the component, slide the power button/LED assembly into the bay until it locks into place.

Storage System Chassis and Backplane

If the backplane board fails or the chassis sustains significant damage, you must order a replacement chassis.

To replace the chassis and backplane:

1.Power down the storage system (on page 9).

2.Remove all hard drive blanks ("Hard Drive Blank" on page 10).

3.Remove all hot-plug SCSI hard drives ("Hot-Plug SCSI Hard Drive" on page 11).

4.Remove the bezel blank ("Bezel Blank" on page 13).

5.Remove the controllers ("Modular Smart Array 500 Generation 2 Controller" on page 13).

6.Remove all hot-plug power supplies ("Hot-Plug Power Supply" on page 17).

7.Remove the 2-Port or 4-Port Shared Storage Module ("2-Port or 4-Port Shared Storage Module" on page 18).