HP VCX Software 12

Chapter 3. Installing 3Com VCX IP Telecommuting Module

Then enter a password for the Telecommuting Module. This is the password you use in your web browser to access and change the Telecommuting Module’s conﬁguration. Finally, you can reset all other conﬁguration if you want to.

Following is a sample run of the installation program.

3Com VCX IP Telecommuting Module Administration

1.Basic conﬁguration

2.Save/Load conﬁguration

3.Become a failover team member

4.Leave failover team and become standalone

5.Wipe email logs

6.Set password

q. Exit admin ==>

Select 1 to install your 3Com VCX IP Telecommuting Module.

Basic unit installation program version 4.3

Press return to keep the default value

Network conﬁguration inside:

Physical device name[eth0]:

IP address [0.0.0.0]: 10.47.2.242

Netmask/bits [255.255.255.0]: 255.255.0.0

Deactivate other interfaces? (y/n) [n]

Computers from which conﬁguration is allowed:

You can select either a single computer or a network.

Conﬁgure from a single computer? (y/n) [y]

If you choose to allow only one computer to conﬁgure the Telecommuting Module, you are asked for the IP address (the mask is set automatically).

IP address [0.0.0.0]: 10.47.2.240

If this IP address is not on the same network as the IP address of the Telecommuting Module, you are asked for the router. Enter the IP address of the router on the network where the Telecommuting Module is connected. Then enter the network address and mask of the network containing the conﬁguring computer .

Static routing:

The computer allowed to conﬁgure from is not on a network local to this unit. You must conﬁgure a static route to it. Give

the IP address of the router on the network the unit is on.

The IP address of the router [0.0.0.0]: 10.47.3.1

Network address [10.47.0.0]: 10.10.0.0

Netmask [255.255.255.0]:

You can choose to allow several computers to conﬁgure the Telecommuting Module, by answering no to the question:

Conﬁgure from a single computer? (y/n) [y] n