HP VCX Software 13

Chapter 3. Installing 3Com VCX IP Telecommuting Module

The installation program then asks for the network number. The network number is the lowest IP address in the series of numbers that includes the conﬁguration computers (see chapter 3 of the User Manual). The network mask determines the number of computers that can act as conﬁguration computers.

Network number [0.0.0.0]: 10.47.2.0

Netmask/bits [255.255.255.0]: 255.255.255.0

If the network or partial network is not directly connected to the Telecommuting Module, you must enter the IP address of the router leading to that network. Then enter the network’s address and mask.

Static routing:

The network allowed to conﬁgure from is not on a network local to this unit. You must conﬁgure a static route to it. Give the

IP address of the router on the network this unit is on.

The IP address of the router [0.0.0.0]: 10.47.3.1

Network address [10.47.0.0]: 10.10.0.0

Netmask [255.255.255.0]:

Then enter a password.

Password []:

Finally, you are asked if you want to reset other conﬁguration.

Other conﬁguration

Do you want to reset the rest of the conﬁguration? (y/n) [n]

If you answer n, nothing is removed. If you answer y, you have three alternatives to select from:

1.Clear as little as possible. This is the alternative that is used if you answer n to the question above. Both the preliminary and the permanent conﬁgurations will be updated with the conﬁguration speciﬁed above.

2.Revert to the factory conﬁguration and then apply the conﬁguration speciﬁed above. This will affect the permanent but not the preliminary conﬁguration.

3.Revert to the factory conﬁguration and empty all logs and then apply the conﬁguration speciﬁed above. Both the preliminary and the permanent conﬁgurations will be affected.

Select the update mode, which is what you want to remove.

Update mode (1-3) [1]:

All conﬁguration is now complete. The installation program shows the conﬁguration and asks if it is correct.

yes saves the conﬁguration.

no runs the installation program over again.

abort ends the installation program without saving.