HP VCX Software Name, Subgroup, Lower Limit, Upper Limit

Chapter 4. Network Configuration

When using an already defined group as a subgroup, select the name of the group under Subgroup. Set Interface/VLAN to ’-’ and leave the other fields empty.

Name

Enter a name for the group of computers. You can use this name when you change configuration on the pages mentioned above. A group can consist of several rows of IP addresses or series of IP addresses. By clicking on the plus sign beside the name, you add more rows where you can specify more IP addresses for this group.

Subgroup

An already defined group can be used as a subgroup to new groups. Select the old group here and leave the fields for DNS name empty. Select ’-’ as Interface/VLAN. If you don’t want to use a subgroup, select ’-’ here.

Lower Limit

DNS Name Or IP Address

Enter the DNS name or IP address of the network or computer. For computers in an IP range that you want to give a network name, enter the first IP address in the range. DNS Name Or IP Address must not be empty if you are not using a subgroup.

IP Address

The IP address of the object you entered in the DNS name or IP address field is displayed here. This field is not updated until you click on Look up all IP addresses again or make changes in the DNS Name Or IP Address field.

Upper Limit

DNS Name Or IP Address

Here, enter the last DNS name/IP address of the network or group. If the network contains a single computer, you can leave this field empty. Then only the IP address in Lower Limit is used.

23