FA 400.2
9. Maintenance and care
Cleaning the cutting block
Strip cut machines: (1 x daily)
•Switch off the shredder.
•Squirt special cutting apparatus oil through the paper feed opening onto the blade roll- ers.
Order no. 1.235.997.401 for a 250 ml bottle Order no. 1.235.997.500 for 5 litre con- tainer
•Let the cutting apparatus run forwards and backwards several times without feeding in any paper.
This loosens paper dust and particles.
Cross cut machines:
|
| If the cutting quality de- |
|
| teriorates or the machine |
|
| becomes noisy: |
| • Let the shredder run without | |
|
| feeding in any paper. |
| • | Push the lever of the oiler |
|
| down several times. |
MAX | • | Make sure the oil level in |
| the container is between the | |
|
| MIN and MAX markings. |
MIN |
| Order no. 1.235.997.500 for |
| 5 litre container | |
Checking the chain tension (twice yearly)
• Switch off the shredder.
• Pull out the power plug.
• Remove the tray and the left cover panel.
The sag of the chain should be 4 – 10 mm.
If you need to tighten the chain:
• Remove the right cover panel.
• Loosen the nuts and push the motor and the tensioning screws until the chain sags by
4 – 10 mm.
• Tighten the nuts again.
• Put the cover panels and the tray back on.
Note:
Do not tighten the chain too much, as this will cause premature wear on the chain and bearings.
10 | 0702 |
