FA 400.2
Inspecting the safety devices
Check that the safety devices are working properly:
• At the start of each shift
• After any maintenance or repair work
Do not start the machine until you have checked the emergency stop button and the door switch and found them to be in perfect working order. If any defect arises during operation stop the machine immediately and make sure it is corrected.
Checking the emergency stop button
Press the emergency stop button while the machine is running.
The shredder must switch off immedi- ately. The cutting block and the feed belt must stop.
The machine will only start again once you have pulled out the emergency stop button again.
Shredding material
Place the material to be shredded on the loading tray and then place batches on the feed belt.
If material that is not supposed to be shred- ded is mistakenly placed onto the belt, never attempt to pull it out.
•Press the stop button. The drive stops.
•Press the reverse button.
The cutting block and feed belt run in reverse.
Inspecting the door switch
• Open the front door.
The red "door open" LED must light up. The cutting block and feed belt must
stop.
After you close the door, the LED should go out and you can start the machine again by pressing the start button.
•You can now remove the material from the belt and start the shredder again by press- ing the start button.
Waste bag full
The red LED on the keypad lights up. The shredder switches off automatically.
• Press the reverse button for approx. 3 seconds.
Part of the material is pulled back into the apparatus.
•Open the front door and shake the waste trolley.
The cut material spreads in the cut mate- rial sack and does not fall into the interior of the shredder.
•Pull the waste trolley out and change the cut material sack.
•Push the trolley back in and start the shredder again by pressing the green start button.
8 | 0702 |
