HSM HSM FA 400.2 manual Operating and display elements on the keypad, Switching on the shredder

FA 400.2

6. Operating and display elements on the keypad

Paper jam or overload

Red LED

Door open

Red LED

Ready for operation

Green LED

Waste bag full

Red LED

Start button

The shredder switches on.

The feed belt moves in the intake direction.

Stop button

The cutting block and feed belt stop. The shredder is in standby mode.

Reverse button

The cutting block and feed belt run in reverse.

7.Start-up, inspecting the safety devices

Attaching the waste bag (Solo version)

•Open the front door and pull out the waste trolley.

•You can modify the trolley from a double-chamber to a single-chamber system by removing the brackets (1).

1

Switching on the shredder

•Pull out the emergency stop button.

•Solo-version: Turn the main switch to the I position.

Combination-version: Turn the main switch on the baling press to the I position.

The green "Ready for operation" LED lights up.

Note:

There is a safety switch on the front door of the shredder. The machine can only be switched on when the door is shut.

•Put in a new waste bag and fold it approximately 20 cm over the top frame tube. When using a two-cham- ber system, make sure that there is also around 20 cm of plastic foil below the brackets (1).

•Push in the waste trolley and close the front door.

• Press the green start button.

The cutting block and feed belt start up.

Caution!

The feed belt can run in reverse if the phase wires in the power plug are incorrectly con- nected.

Turn off the main switch immediately and pull out the power plug!

Have an electrician change two of the three phase wires

0702 7