ASSEMBLY
4LOWER CHUTE
1.Turn mower engine off.
2.Raise and hold deflector shield in upright position.
3.Place slot in lower chute over tab on mower deck and position lower chute over deck opening as shown.
4.Hook rear latch into flange hole on back of mower deck.
5.Hook front latch into tab hole on front of mower deck.
CAUTION
Before raising deflector shield, turn mower engine off. DO NOT remove deflector shield from mower. Raise and hold shield when attaching lower chute and allow it to rest on chute while in operation.
Deflector
Shield
Tab
Front
Latch
Rear Latch
5UPPER CHUTE
1.Lower mower deck to its lowest cutting position.
2.Assemble upper chute by inserting curved end into hole in back of cover.
NOTE: Handle carefully so as not to damage dump bag indicator.
3.Push in and turn upper chute until it is in line with lower chute.
4.Align the bosses on lower chute with alignment slots on upper chute with alignment slots on upper chute and slide together.
5.Secure with rubber latch by hooking hole in latch over latch pin.
Upper | Dump Bag | Handle | |
Indicator | |||
Chute |
| ||
|
|
Cover
Lower
Chute
Alignment |
|
Slot | Latch Pin |
|
Rubber
Latch
Bosses
6 LEVEL MOWER DECK
Be sure deck is properly leveled for best mower perfor- mance. See your mower operator’s manual for instruc- tions.
10
