LAN MAC Filter
Your gateway supports MAC filtering based on a list of either denied or allowed computers.
A common method to restricting network access is to specify the Media Access Control
(MAC) address.
To locate the MAC address in Windows, choose Start > Run, and then enter cmd.
The command window is displayed, enter ipconfig /all, and then press Enter.
The MAC address is displayed as the Physical Address.
to access the LAN MAC Filter window.
1. Click
2. Select MAC Filter Mode.
Mode Description
Disabled It specifies that the MAC address filter function is disabled.
It specifies that the clients with addresses in the MAC Address list are
allowed to connect with the gateway.
Allow
It specifies that the clients with addresses in the MAC Address list are
denied to connect with the gateway.
Deny
3. Enter the MAC addresses of the clients and click
LAN IP Filter You can configure the gateway to block specific IP addresses from accessing the LAN.
to access the IP Address Filter window.
Click
Adding an IP Address
1. Select the protocol and status.
2. Enter the IP address and corresponding port to be blocked from accessing the LAN.
to add the IP address to the table.
3. Click
Modifying an IP Address
1. Click in the Modification column. The corresponding IP address filter is
displayed.
2. Modify the contents as required.