Huffy 7900 manual Section a Assemble the Poles, Label

SECTION A: ASSEMBLE THE POLES

1. Correctly identify each pole section. Poles have an identification sticker that will be used as a
reference point in the next step.	1

Pole Identification Sticker

3

2

WARNING	Pole Identification Sticker
LABEL

2. Align dimple of top pole with slot of middle pole. While maintaining alignment, bounce middle pole (2) into top pole section (1) using a wood scrap as shown until top pole no longer moves toward pole identification mark on middle pole.

	CAUTION!
	THE IDENTIFICATION STICKER IS
	LOCATED 5" FROM THE END OF
	THE POLE. WHEN PROPERLY
	POUNDED TOGETHER, THE POLE
	SECTIONS SHOULD HAVE A 3-1/2"
	MINIMUM OVERLAP, LEAVING 1-	Pole
	1/2" BETWEEN THE OVERLAPPING
	POLE AND THE IDENTIFICATION
	STICKER.	Identification
IDENTIFICATION	2	Mark
STICKER
	pole middle
	5"
1
	2
IDENTIFICATION
STICKER
	pole middle

1-1/2"

1

2

1

WOOD SCRAP

(NOT SUPPLIED)

9 03/04 P/N 21447703