Huffy M5800152 manual FIG a

IMPORTANT!

ONCE POLE SECTIONS ARE POUNDED TOGETHER - THEY CANNOT BE TAKEN APART

2. Align poles using alignment marks. First, pound top and middle poles together by bouncing them on a scrap piece of wood on the ground as shown in FIG A. until they no longer move toward pole identification stickers. THEN add bottom pole section and pound together in the same way.

TOP

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 3-3/4" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 2-1/2" MINIMUM OVERLAP, LEAVING 1-1/4"

BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

2

alignment mark

MIDDLE

FIG A.

scrap wood (Not Supplied)

IDENTIFICATION

STICKER

middle pole

3-1/2”

3

alignment mark

BOTTOM

IDENTIFICATION
STICKER	1-1/4"
	middle pole

4

ID# M5800151 11/05 8