3.Align dimple of middle pole with slot of bottom pole. While maintaining alignment, bounce top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no longer move toward pole identification mark.

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2"

MINIMUM OVERLAP, LEAVING 1- 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

NOTE:

POLE SECTIONS

SHOULD HAVE A

3-1/2" (9 CM) MINIMUM

OVERLAP.

1

POLE

IDENTIFICATION

MARK

2

3

WOOD SCRAP

(NOT SUPPLIED)

2

5"

Bottom Pole

IDENTIFICATION

3

STICKER

2

IDENTIFICATION

1-1/2"

Bottom Pole

STICKER

 

3

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH

THE HARDWARE

IMPORTANT!:

Holes in top (1) and bottom pole (3) sections MUST align to correctly position elevator system toward playing surface.

P/N 21147703 03/04

10

Page 10
Image 10
Huffy P/N 21147703 manual Pole Sections Should have a