Water Type, Alarms Menu Tab | Humminbird 343c specs

531447-1_A_343c_Eng.qxd 11/11/2005 9:18 PM Page 44

Water Type

(Advanced)

Water Type configures your unit for operation in fresh or salt water. The Water Type menu choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).

NOTE: In salt water, what would be considered a large fish might be 2 to 10 times bigger than a large fish in fresh water (depending on the type of fish you are seeking). The salt water setting allows for a greater range in fish size adjustment to account for this. Also, make sure that the Water Type is set accurately, especially in salt water, as this affects the accuracy of deep water depth readings.

Alarms Menu

To change the Water Type setting:

1.Make sure you are in Advanced User Mode, then highlight Water Type on the Sonar main menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Water Type setting. (Fresh, Salt, Default = Fresh)

Alarms Menu Tab

From any view, press the MENU key twice to access the Main Menu System. The Alarms tab will be the default selection.

NOTE: When an alarm is triggered, you can silence it by pressing any key. The alarm will be silenced, and will not be triggered again until a new instance of the alarm condition is detected.

39

40

Image 23

Humminbird 343c manual Alarms Menu Tab, To change the Water Type setting

Contents

343c Operations Manual Thank You Table of Contents Specifications Glossary Contact Humminbird Alarms Menu TabSetup Menu Tab Troubleshooting How Sonar Works DualBeam Plus Sonar High Sonar Intensity Return Bait Ball What’s On the Display Sonar View Views Freeze Frame Understanding Sonar HistoryReal Time Sonar RTS Window Bottom Presentation 200/83 kHz Split Sonar View Sonar Zoom View Circular Flasher View POWER/LIGHT KeyBig Digits View Key Functions Exit Key Menu KeyWAY Cursor Control Key Menu System Powering Up the Unit Normal Simulator System Status Exit Normal operation by powering your Fishing System offStart-Up Options Menu Normal Operation Simulator Self Test Accessory TestExit the Simulator by powering your Fishing System off Exit System Status by powering your Fishing System off Highlight Sensitivity on the Sonar X-PressTMMenu To adjust the SensitivitySonar X-PressTMMenu Sensitivity Lower Range To adjust the Upper RangeTo adjust the Lower Range Upper Range Bottom Range Chart SpeedZoom Level Bottom Lock Highlight Beam Select on the Sonar main menu Sonar Menu TabBeam Select To use Beam Select Fish ID Sensitivity To change the Fish ID Sensitivity settingTo change the RTS Window setting Fish ID+TM Depth Lines Bottom ViewZoom Width KHz Sensitivity Max Depth Surface ClutterNoise Filter Water Type Alarms Menu TabTo change the Water Type setting Temp Alarm Depth AlarmFish ID Alarm Low Battery Alarm Highlight Alarm Tone on the Alarms main menu Alarm ToneSetup Menu Tab To change the Alarm Tone setting Units Distance User ModeUnits Depth Units Temp Select Views Triplog ResetRestore Defaults Temp Offset Select ReadoutsDepth Offset Speed Calibration TroubleshootingTo change the Speed Calibration setting Isolation Display ProblemsProblem Possible Cause Finding the Cause of Noise Sonar Terms SpecificationsGlossary 531447-1A343cEng.qxd 11/11/2005 918 PM 531447-1A343cEng.qxd 11/11/2005 918 PM Receiver See Transmitter 531447-1A343cEng.qxd 11/11/2005 918 PM Contact Humminbird