. | m | .com |
|
www.reelschel | atic. | 1 | |
|
|
| |
Screen Capture and Side Imaging Cursor | |||
Thank You
Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation by designing and manufacturing
Contact our Customer Resource Center at either
Feature Overview
This sheet describes two new features that have been added to your 900 Series:
•Screen Capture
•Side Imaging Cursor.
Screen Capture
When Screen Capture is enabled (from the Accessories menu tab), pressing the MARK key creates a saved screen capture on the
NOTE: You must have an
NOTE: If your unit does not have a MARK key, use the Preset View key on the far right and top of the keypad instead.
1. Enabling Screen Capture
Turning on Screen Capture allows you to capture screen images using the MARK key (or far right Preset View key if your unit does not have a MARK key). All menus, dialog boxes, warnings and messages are captured and saved automatically. You can view these captures on the Screen Capture View, which shows thumbnails of the screen captures, three at a time.
To turn on Screen Capture:
1.Highlight Screen Capture on the Accessories Menu.
2.Select On to enable, or Off to disable this feature.
2. Making a Screen Capture
Once Screen Capture is enabled from the Accessories Menu Tab, perform the following steps to capture a screen:
NOTE: The MARK key only functions if you have a GPS receiver connected, or if you have enabled Screen Capture from the Accessories menu tab. If you have enabled the Screen Capture feature, pressing the MARK key (or far right Preset View key if your unit does not have a MARK key) still creates a waypoint, but it also captures the screen image to the
1.Make sure you have installed an
2.From any view you want to capture, press the MARK Key (or the far right Preset View key if your unit does not have a MARK Key). When you start a screen capture, you will see a message that a waypoint has been created at the point where your cursor is on the screen, and the screen will freeze. A status dialog box will appear that shows the progress of the save, and that displays the numbered filename assigned to the .BMP file that is being created, along with the percentage completed status.
NOTE: Navigation is not affected by the Screen Capture feature. Also, if Screen Capture is enabled but there is no GPS
receiver connected, pressing the MARK key (or far right Preset View key if your unit does not have a MARK key) will capture the screen image and display an error saying that a GPS position fix is required to create a waypoint.
NOTE: The speed of the capture depends on the type of card you use; in general, SD cards capture the screen faster than MMC cards do.
© 2005 Humminbird®, Eufaula AL, USA. All rights reserved.
