Installation Overview, Accessory Bus | Humminbird 967C specs

Installation Overview

Please read all instructions that are relevant for your configuration before beginning the installation process.

NOTE: Installation procedures will depend on product configuration.

The 900 Series™ has a wide variety of configurations.

2

		1
	3
		8
	4
		6
		7
	5	Accessory Bus
		Accessory Bus
1	Sonar Transducer w/Temperature	Speed through water	5
2	Optional “Y” Cable	GPS Receiver	6
3	Power	WeatherSense®	7
4	Temperature	SmartCast® Wireless Sonar Link	8

5

Image 13

Humminbird 967C manual Installation Overview, Series has a wide variety of configurations, Accessory Bus

Contents

Page Humminbird, Eufaula AL, USA. All rights reserved Thank You Table of Contents Iii Views Start Recording Upper RangeStop Recording Delete Image Sonar Menu Tab Delete All Nav Data Export All Nav Data101 102 Vii How the 900 Series Works Series Introduction 3D Sonar Peak to Peak measures power output at the highest points2D Sonar How GPS and Cartography Work Multi-Media Card MMC/SD Slot Software Updates Accessory Bus 900 Series has a wide variety of configurations Installation OverviewAccessory Bus Basic installation tasks that you must perform include Control Head InstallationGimbal Mounting the Control Head Page Mounting Screws Cables Routed Behind Mounting Bracket Cables Routed Directly Beneath Mounting Bracket Plug Cable Connector Assembly to Connecting the Control Head Power Cable to the Boat Transom Transducer Installation Transducer Installation Mount the transducer bracket to the boat Determine transducer mounting location Attaching the Bracket Attach the pivot to the transducer Adjust the running position of the transducer Mount the transducer pivot assembly to the bracketInstallation after high speed testing Normal Cavitation Tighten the Pivot Screws Route the transom transducer cable Perform a final test of the transom transducer installation Inside the Hull Transducer InstallationRouting the Cable Preferred Mounting Area Determine the transducer mounting location Trial installation Permanently mount the transducer Route the cable Test and Finish the Transducer Installation Trolling Motor Transducer InstallationTrolling Motor Transducer Options Are included with the bracket If you have… Then use GPS Receiver Installation Follow these steps to stem mount the GPS receiver Stem Mounting with an Existing 1 14 Thread StemAbrasion No Access Under Mounting Location Access Under Mounting Location Finish Routing the Cable Check GPS Receiver Operation Install the temperature probe accessory Temperature Probe Accessory InstallationRouting the cable to the control head To test the installation Testing the System Installation Powering Up the Control Head Getting Started Using Your 900 Series What’s On the 3D Sonar Display Timer Elapsed time with Speed input or GPS Receiver RTS Real Time Sonar Window What’s On the 2D Sonar Display Bottom Presentation Real Time Sonar RTS Window Key Functions POWER/LIGHT Key Menu Key View Key WAY Cursor Control Key View Preset keysExit Key Mark Key Info KeyGoto Key Goto Key has multiple functions, depending on the situation Views Zoom +/- KeysViews and Readouts 3D/2D Combo View 2D Sonar View 2D Sonar View 2D Zoom View 2D Zoom View Beam Sonar View Snapshot and Recording View Snapshot and Recording ViewPage Recording Slider Bar Recording Playback Bird’s Eye View Bird’s Eye View Chart/Bird’s Eye Combo View Chart/Chart Combo View Chart/Chart Combo View Chart View Chart/3D Combo View Chart/3D Combo View Chart/2D Combo View Viewing Cartography Chart Orientation Navigation Waypoints, Routes and Tracks Waypoints, Routes and Tracks Save, Edit, or Delete a Waypoint Add a Waypoint Target or Trolling Grid Navigate to a Waypoint or Position Save, Edit or Delete a Route Chart View with Grid Edit, Delete or Hide Saved Tracks Save or Clear a Current Track Man Overboard MOB Navigation Menu System Normal Simulator System Status Start-Up Options Menu Normal Operation Exit Normal operation by powering your 900 Series offSimulator System Status Accessory Test Screen Accessory TestSelf Test GPS Diagnostic View Active Side 2D Sonar X-Press Menu2D Sonar Views only Sensitivity Split Position Lower Range Upper Range 2D Zoom View only, when Bottom Lock is On Chart SpeedBottom Lock Bottom Range Only when Navigating Cancel Navigation2D/3D Priority 3D Sonar Views only 3D Sonar X-Press Menu 3D Bottom Zoom Beam Sensitivity3D Lower Range Beam Sonar View only 3D History Reset 3D View Left Cursor key Navigation X-Press Menu Only with an active cursor on a waypoint Waypoint Name Cursor to Waypoint Chart or Combo view onlySave Current Track Clear Current Track Save Current Route Cancel MOB NavigationSkip Next Waypoint Remove Grid Remove TargetOnly if a Target is active Only if a Grid is active Snapshot and Recording View only Snapshot and Recording Press MenuSnapshot and Recording PressMenu Stop Recording Start RecordingDelete Image Delete Recording Delete All Images Pings Per Second Delete All RecordingsTo specify the pings per second Stop Playback Playback SpeedTo specify playback speed 2D Sonar Colors Sonar Menu Tab3D Bottom Style Sonar Menu 2D Beam Select 3D Frame StyleFish ID+ Fish ID 3D Reference Fish ID Sensitivity Zoom Width Bottom ViewRTS Window Narrow RTS Window Off Depth Lines KHz SensitivityAdvanced Depth Lines Noise Filter Surface Clutter Max Depth To change the Max Depth settingWater Type 2D Sonar View only, with Temperature input Temperature GraphColor Bar Navigation Menu Tab Saved Tracks Current TrackCurrent Track Submenu Saved Tracks Submenu Routes WaypointsWaypoints Submenu contains the following menu choices Waypoints Submenu Trolling Grid Rotation North Reference Track Min Distance Trackpoint Interval Map Datum Track Color RangeCourse Projection Line Export All Nav Data Chart Menu Tab Continuous Navigation ModeContinuous Navigation Mode allows you to Delete All Nav Data Map Borders Chart Detail Level Spot Soundings Lat/Lon GridNavaids on Birds Eye View Shaded Depth Set Map Offset Set Simulation Position Clear Map Offset Alarms Menu Tab Fish ID Alarm Depth AlarmLow Battery Alarm Temp Alarm Aux Temp AlarmWith optional-purchase temp. probe or Temp/Speed only 100 Arrival Alarm Off Course AlarmOff Course Alarm Alarm Tone Drift AlarmDrift Alarm Circle Setup Menu Setup Menu TabUnits Depth Units Temp Units Distance User ModeUnits Speed Language Restore Defaults Triplog ResetOff Triplog Position Voltage Aux. Temperature Select ReadoutsPage Aux. Temp. Offset Depth OffsetTemp. Offset Local Time Zone Speed CalibrationDaylight Saving Time Position Format Date Format Time FormatDigits Format Advanced, International only Sonar Nmea Output110 Views Menu Tab Using Screen Snapshot Accessories Menu TabPage Series Doesn’t Power Up Troubleshooting114 Control head loses power at high speeds Display Problems115 Finding the Cause of Noise 117 Year Limited Warranty Returning Your Unit for Service Humminbird Service Policy118 Series include Series AccessoriesPage Area of Coverage kHz 74 @ -10 dB 455 kHz 53 @ -10 dB Specifications121 122 Glossary 123 Glossary 125 Receiver See Transmitter Glossary 127 Glossary Sonar Terms Glossary 129 Glossary Glossary Appendix A, Transducer Mounting Template SHS 7W 133 134 135 Contact Humminbird