Transducer Installation

There are three different installation methods for your transducer:

Transom Transducer

Inside the Hull Transducer

Trolling Motor Transducer.

Find the section that describes the method of installation you will be using.

NOTE: If the included transducer will not work for your application, you may exchange it, NEW and UNASSEMBLED, with mounting hardware included, for a transducer appropriate for your application - often at very little or no charge, depending on the transducer. Call the Humminbird® Customer Resource Center (1-800-633-1468) for details and pricing, or visit www.humminbird.com, Product Support/Transducer Exchange for more information.

NOTE: Due to the wide variety of hulls, only general instructions are presented in this installation guide. Each boat hull represents a unique set of requirements that should be evaluated prior to installation. In addition to the parts supplied, you will need a hand drill with various bits, a socket wrench (5/16"), a Phillips head screwdriver, and marine-grade silicone sealant.

NOTE: When drilling holes in fiberglass hulls, it is best to start with a smaller bit and use progressively larger drill bits to reduce the chance of chipping or flaking the outer coating. Fill all holes with marine grade silicone sealant.

WARNING: Do not touch an active transducer during operation, as this may cause physical discomfort and may result in personal injury in the form of tissue damage. Handle the transducer only when the power to the control head is off.

Transom Transducer Installation

If you will be installing a transom mounted transducer, use the procedures in this section. There are several procedures you will have to perform in order to install a transom-mounted transducer. They are:

Determine transducer mounting location

Mount the bracket to the boat

Attach the pivot to the transducer

Mount the transducer pivot assembly to the bracket

Adjust the running position of the transducer

Route the transducer cable

Perform a final test of the transom transducer installation.

 

 

 

 

Stepped Hull

 

 

 

 

 

3

 

1

 

2

 

 

 

 

 

 

 

 

1

Rivets/Strakes

2

Deadrise Angle

Step

3

12

Page 20
Image 20
Humminbird 967C manual Transom Transducer Installation