4 • Receiver Installation
NOTE: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire leaving
a minimum of 6 inches remaining. Restrip the fan lead wires 1/2 inch. Place remaining excess wire into the ceiling electrical box as needed.
Hands
Free
Figure 7
Hunter
Bracket Hanger: Starting with the antenna wire, slide receiver inside mounting bracket. If a ground wire mounting screw prevents the receiver from sliding into the bracket, move ground wire and screw to an unused hole at the top of the bracket or secure with a canopy mounting screw. The bracket must remain properly grounded. Connect wiring as shown in Figure 8. Extend antenna above the receiver (approximately
Figure 8
Bracket |
Hanger |
6
