Hunter Fan 28982, 28983, 28984 Installing The Accessory Light Kit, Installing The Bulbs And Globes

	W ires to Light Sockets
Bellmouth Nut		Bellmouth Nut

Light Switch	Fan Speed
	Switch

Capacitor

Capacitor

LOW ER PLUG

CONNECTOR

HOUSING A SSEM BLY

SCREW

UPPER SW ITCH HOUSING

UPPER PLUG

CONNECTOR

LIGHT K IT

M ulti-wire Plug
Connection	#6-62 Housing
	Assembly Screws

Reverse Switch

FIGURE 2

CAUTION

Be sure no bare wire or wire strands are visible after making connections.

3.Insert the chain and fan pull chain switch through the round opening on the side of the modular accessory light kit. Thread the bellmouth nut over the pull chain and hand tighten the bellmouth nut.

4.Reattach the patented breakaway connector to the end of the pull chain.

5.Insert the reversing switch into the square hole on the side of the modular accessory light kit. Install and tighten the two screws you removed in Step 1, substep 1.

6.Carefully place the capacitors in the modular ac- cessory light kit.

You have completed the assembly of the modular accessory light kit and are ready for installing the modular accessory light kit to the fan.

STEP 3: INSTALLING THE ACCESSORY LIGHT KIT

NOTE: Refer to Figure 3 for the steps listed below.

1.Connect the lower (mutli-wire) plug connector from the modular accessory light kit to the up- per plug connector from the motor.

NOTE: Both plug connectors are polarized and will only fit together one way. Make sure that both connectors are properly aligned before connect- ing them together. Incorrect connection could cause improper operation and damage to the product.

FIGURE 3

2.Place the modular accessory light kit over the up- per switch housing. Align the side screw holes in the upper switch housing and the modular acces- sory light kit. Attach the modular accessory light kit to the upper switch housing with the three #6-32 X 3/8" housing assembly screws.

STEP 4: INSTALLING THE BULBS AND GLOBES

NOTE: Refer to Figure 4 for the steps listed below. 1. Insert a globe into the cup.

2. Tighten the thumbscrews manually. Do Not overtighten.

3.Repeat substeps 1 and 2 for the remaining three globes.

4.Install a 60W medium base incandescent bulb into each socket.

You have completed the installation of the modular accessory light kit. Refer back to the “ Operating Your Hunter Fan” section in the Installation/Owner’s Manual provided with your Hunter fan for proper operation instructions.

THUM B-

SCREW S

CUP

GLOBE

FIGURE 4

Hunter Fan Company

2500 Frisco Avenue

Memphis, TN 38114

USA

© 2005 Hunter Fan Co.

41490-01 12/01/2005