Step 10: Install Globe
A. Install the glass globe assembly to fixture fitter. See Figure 10.
FIXTURE FITTER
GLOBE ASSEMBLY
Figure 10
Step 11: Operation of Remote Control
Operating Instructions: The
INDICATOR
LAMP
LIGHT
FAN
FIGURE 11
Lift the globe assembly until it’s free to rotate in either direction. Rotate the globe assembly until the (3) screw clearance holes in the globe trim line up with the matching threaded holes in the fixture fitter. See Figures 10 and 10A.
Secure the globe assembly to the fitter using (3) screws found in sack parts. See Figure 10A.
Tighten all (3) assembly screws.
CAUTION: Failure to securely tighten the (3) assembly screws could result in the globe assembly falling.
ASSEMBLY SCREW
CLEARANCE HOLE
Figure 10A
NOTE: Be sure to install a fresh battery. Check for weak battery if fan fails to operate properly.
The fan may be started by pressing one of the buttons marked “1,” “2,” or “3,” for high, medium, or low, respectively. Pressing the
button marked “FAN” will turn the fan off. The button is for reversing. When this button is pushed the fan will reverse its direction of rotation.
Wall Mount: A holder is supplied with the transmitter which can be mounted to a convenient location on a wall. The holder will help prevent misplacement of your transmitter by providing a permanent receptacle. See Figure 11A.
If desired, the holder can be mounted directly over the wall switch.
FIGURE 11A | HOLDER |
6 | © 2002 Hunter Fan Company™ |