Hunter Fan 41844-01 manual Installing the canopy trim ring, Removing the canopy trim ring

6

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, you should use a qualified electrician.

		(Note: Wall
Wall Switch Wire for Separate		switch must be
Control of Light Fixture		acceptable as a
		general-use
Power
	Black	switch.)
Wires
in	White
Ceiling	Bare or Green
2 x 4 Brace		Outlet Box

3.Raise the canopy, be sure the holes in the canopy and the ceil- ing plate are aligned, and loosely assemble the canopy screws one at a time. When all three screws are assembled, securely tighten all three canopy screws. Refer to Figure 15.

Tab Hole

and Tab

Canopy

Screw

Figure 15 - Installing the canopy

Approved

Connectors

Green Ground Wire from Hanger Pipe (not present with flush mounting option)

White Black

1

2

Blk/Wht

3Wires from Fan

Ceiling Plate

Connections:

1.Connect Blk/Wht wire from the fan to the wall switch for separate control of the light fixture, or

2.Connect Blk/Wht wire from the fan to the ceiling black wire if there is no separate wall switch wire for the light fixture.

installing the canopy trim ring

1.To easily install the canopy trim ring, locate the two tabs on the canopy trim ring. See Figure 16.

	Canopy
Press Here when	Press Here when
Removing	Removing

Figure 13 - Wiring the fan

installing the canopy

1.Rotate the fan 180º clockwise from the initial position when hanging the fan. The arrows on the hanger ball and on the ceiling plate should be pointing in the same direction and should be pointing towards the tab hole on the canopy. Refer to Figure 14.

Figure 14 - Rotating the fan

2.Hook the tab hole over the tab on the ceiling plate as shown in Figure 15.

Canopy
Trim Ring	Tab

Figure 16 - Canopy trim ring

2.Take both hands and push the canopy trim ring up to the top of the canopy. See Figure 16.

3.The canopy trim ring will snap and lock into place on the canopy.

removing the canopy trim ring

1.Locate the tab indicators, small bumps on top of tabs. Refer to Figure 17.

2.To remove the canopy trim ring, press firmly on opposite sides of the ring towards the canopy as shown in Figure 17. The tabs will flex out releasing the trim ring from the canopy.

Tab Indicator Canopy Trim Ring

Canopy

Figure 17 - Removing the canopy trim ring

41844-01 12/20/2002 © 2002 Hunter Fan Company