10

installing without the light fixture

Your Hunter fan comes with an integrated light fixture assembly and an optional switch housing cap and plug button. This feature gives you the option of installing the fan with or without the included light fixture.

attaching the upper switch housing

1.Partially install two #6-32 x 3/8" housing assembly screws into the switch housing mounting plate as shown in Figure 26.

2.Feed the upper plug connector through the center opening of the upper switch housing. See Figure 26.

3.Align the keyhole slots in the upper switch housing with the housing assembly screws installed previously.

4.Turn the upper switch housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots as shown in Figure 27. Install the one re- maining #6-32 x 3/8" housing assembly screw into the third hole in the upper switch housing. Tighten all three screws firmly.

CAUTION: Make sure the upper switch housing is se- curely attached to the switch housing mounting plate. Fail- ure to properly attach and tighten all three housing as- sembly screws could result in the switch housing and light fixture falling.

attaching the lower switch housing

1.Connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly. See Fig- ure 30.

NOTE: Both plug connectors are polarized and will only fit to- gether one way. Make sure that both connectors are properly aligned before connecting them together. Incorrect connec- tion could cause improper operation and damage to the prod- uct.

2.Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the up- per switch housing with three #6-32 x 3/8" housing assembly screws. See Figure 30.

operating your ceiling fan

1.Turn on electrical power to the fan.

2.The fan pull chain controls power to the fan. The pull chain has four settings in sequence: High, Medium, Low and Off.

•Pull the chain slowly to change settings.

•Release slowly to prevent the chain from recoiling into the blades.

•The chain uses a breakaway connector that separates if the chain is jerked. If this happens, simply reinsert the chain into the connector.

3.The light pull chain controls power to the light. The pull chain has two settings: On and Off.

4.Ceiling fans work best by blowing air downward (counterclock- wise blade rotation) in warm weather to cool the room with a direct breeze. In winter, having the fan draw air upward (clock- wise blade rotation) will distribute the warmer air trapped at the ceiling around the room without causing a draft. Refer to Figure 32.

Figure 32 - Air flow patterns

To change the direction of air flow, turn the fan off and let it come to a complete stop. Slide the reversing switch on the fan to the opposite position as shown in Figure 33. Restart fan.

Fan PullReversing

ChainSwitch

Figure 33 - Pull chain and reversing switch

41847-01 04/21/2003

© 2003 Hunter Fan Company