9
Lower Switch
Housing
Light Fixture
Figure 28 - Assembling the light fixture
3.Securely tighten the light kit assembly into the bottom of the lower switch housing. Refer to Figure 29.
Figure 29 - Attached light fixture
4.Install the nut and washer onto the end of the light kit assem- bly inside of the lower switch housing. Securely tighten the nut and washer. Insert and tighten the two
5.Using the wire nuts on the two light kit wires in the lower switch housing, connect the black wire from the light kit assembly to the black/white wire from the lower switch housing and con- nect the white wire from the light kit assembly to the white wire from the lower switch housing.
attaching the lower switch housing1.Connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly. See Fig- ure 30.
NOTE: Both plug connectors are polarized and will only fit to- gether one way. Make sure that both connectors are properly aligned before connecting them together. Incorrect connec- tion could cause improper operation and damage to the prod- uct.
|
| Upper Switch |
|
| Housing |
| Lower Plug | Upper Plug |
| Connector | |
| Connector | |
|
| |
Housing |
| Lower |
Assembly |
| Switch |
Screw |
| Housing |
Figure 30 - Connecting the plug connectors
2.Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the up- per switch housing with three
Refer to Figure 31.
1.Install two max 60 Watt medium base incandescent bulbs.
2.Attach the extra pull chain (included in the sack parts) to the fan pull chain using the plastic breakaway connector.
3.Thread the fan pull chain through the hole in the metal disk. Then, thread the fan pull chain through the small hole beside the hole in the center of the glass bowl.
4.Thread the light pull chain through the hole in the center of the glass bowl.
5.Place the cover plate up against the glass bowl. Align the holes in the cover plate and glass bowl.
6.Thread the fan pull chain and light pull chain through the ap- propriate holes.
7.Thread the light pull chain through the finial and screw the finial onto the threaded rod end until tight.
| Lower Switch |
Fan Pull Chain | Housing |
| |
| Threaded Rod |
Glass Bowl | Metal Disk |
| |
| Light Pull Chain |
Cover Plate
Finial
Figure 31 - Installing the glass bowl
© 2003 Hunter Fan Company |