6
6.Place the canopy trim ring then the canopy over the adapter as shown in Figure 15.
7.Place the low profile washer (lip up) into the canopy as shown in Figure 15 fitting the notch in the low profile washer over the adapter set screw and hook.
Tab Hole | Low Profile Washer |
|
Canopy
Canopy Trim Ring
Arrow on the
Low Profile
•control the light with one wall switch and the fan with another (two wall switches required).
Use connection 2, as described in Figure 17, if there is no separate wall switch power wire for the light fixture.
NOTE: Wall switches not included.
3.Connect the wires as shown in Figure 17. To connect the wires, twist the bare metal leads together. Place a wire nut over the intertwined length of wire and twist clockwise until tight as.
CAUTION: Be sure no bare wire or wire strands are vis- ible after making connections.
All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, you should use a qualified electrician.
Washer
Figure 15 - Assembling canopy for low profile mounting
Wall Switch Wire for Separate Control of Light Fixture
Power
(Note: Wall switch must be acceptable as a
8. Rotate the canopy until the arrow on the low profile washer |
Wires
Black
switch.)
aligns with the tab hole on the canopy as shown in Figure 15. |
9. Align the holes in the low profile washer with the holes in the |
adapter and assemble securely with the three |
hanging the fan
in White
Ceiling
Bare or Green
2 x 4 BraceOutlet Box
1.Raise the fan and place the hook through the loop on the ceil- ing plate as shown in Figure 16. Use the note and arrow en- graved in the ceiling plate to assist in determining the direc- tion to assemble.
WARNING: Fan may fall if not assembled as directed in these installation instructions.
HookLoop
Approved
Connectors
Green Ground Wire from Hanger Pipe (not present with flush mounting option)
White | Black |
1
2
Blk/Wht
3Wires from Fan
Ceiling Plate
Connections:
1.Connect Blk/Wht wire from the fan to the wall switch for separate control of the light fixture, or
2.Connect Blk/Wht wire from the fan to the ceiling black wire if there is no separate wall switch wire for the light fixture.
Figure 16 - Hanging the fan
wiring the fan
1.Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.
2.You can use either one or two wall switches to control the fan and/or lights separately. Use connection 1, as described in Fig- ure 17, to
•control the light with a wall switch and the fan with a pull chain (one wall switch required),
•control the light with a pull chain and the fan with a wall switch (one wall switch required), or
Figure 17 - Wiring the fan
installing the canopy
1.Rotate the fan 180º clockwise from the initial position when hanging the fan. The arrows on the hanger ball and on the ceiling plate should be pointing in the same direction and should be pointing towards the tab hole on the canopy. Refer to Figure 18.
Figure 18 - Rotating the fan
© 2003 Hunter Fan Company |