8

Blade Iron

Medallion

Figure 24 - Attaching the blade to the blade iron and

medallion

If you used grommets, the blades may appear slightly loose after screws are tightened. This is normal.

3.Remove the blade mounting screws and rubber shipping bumpers from the motor.

4.For each blade, insert one blade mounting screw through the blade iron as shown in Figure 25, and attach lightly to the fan. Insert the second blade mounting screw, then securely tighten both mounting screws.

Figure 25 - Attaching the blade iron to the fan

installing the light fixture

You can install with or without the light fixture. If you want to install without the light fixture, skip to the installing without the light fixture section.

WARNING: Use only the supplied light fixture for this fan model.

attaching the upper switch housing

1.Partially install two #6-32 x 3/8" housing assembly screws into the switch housing mounting plate as shown in Figure 26.

2.Feed the upper plug connector through the center opening of the upper switch housing. See Figure 26.

Switch Housing

Housing

Assembly

Mounting Plate

Screw

Upper Plug

Connector

Upper Switch

Housing

Figure 26 - Attaching the upper switch housing to the

mounting plate

3.Align the keyhole slots in the upper switch housing with the housing assembly screws installed previously.

4.Turn the upper switch housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots as shown in Figure 27. Install the one re- maining #6-32 x 3/8" housing assembly screw into the third hole in the upper switch housing. Tighten all three screws firmly.

Figure 27 - Mounting the upper switch housing

CAUTION: Make sure the upper switch housing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three housing assembly screws could result in the switch housing and light fixture falling.

attaching the light fixture to the lower switch housing

1.Uninstall the switch housing cap and plug button.

NOTE: Do not discard any parts. You will need to replace it if you remove the light fixture in the future.

2.Insert the black wire and white wire from the light kit assem- bly through the hole in the bottom of the lower switch hous- ing. Refer to Figures 28 and 29.

41847-01 04/21/2003

© 2003 Hunter Fan Company