5
Slots
Arrows for Orienting on Angled Ceiling
Figure 8 - Locating the slotted holes to use
6.Place a flat washer on each of the two 3" screws and pass the screws through the slotted holes in the ceiling plate as shown in Figure 9.
7.Tighten the screws into the 9/64" pilot holes; do not use lubri- cants on the screws. Do not overtighten.
Ceiling Joist
2" x 4" Brace
Ceiling Plate | Celing |
Flat Washer | Outlet Box |
| |
| 3" Wood Screw |
Figure 9 - Installing the ceiling plate
assembling the fan
assembling the fan for a standard or angled ceiling
1.Insert the pipe through the canopy and adapter cover with the adapter ring assembled. To keep the adapter ring as- sembled, twist the adapter cover around the downrod. Refer to Figure 12. Feed wires from the fan through the downrod.
2.Screw the downrod into the fan assembly until tight. IMPOR- TANT! Tighten downrod set screw as shown in Figure 10.
CAUTION: The downrod has a special coating on the threads. Do not remove this coating; the coating prevents
the downrod from unscrewing. Once assembled, do not remove the downrod.
3.Slide the adapter cover down by twisting it around the downrod until it is flush to the top of the motor housing.
4.Continue to the hanging the fan section.
Hanger Ball/
Downrod Assembly
Canopy
Adapter Cover
Set Screw
Figure 10 - Assembling the downrod
hanging the fan
1.Raise the fan and place the hook through the loop on the ceil- ing plate as shown in Figure 11. Use the note and arrow en- graved in the ceiling plate to assist in determining the direc- tion to assemble.
WARNING: Fan may fall if not assembled as directed in these installation instructions.
HookLoop
Figure 11 - Hanging the fan
wiring the fan
1.Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.
2.You can use either one or two wall switches to control the fan and/or lights separately. Use connection 1, as described in Fig- ure 12, to
•control the light with a wall switch and the fan with a pull chain (one wall switch required),
•control the light with a pull chain and the fan with a wall switch (one wall switch required), or
•control the light with one wall switch and the fan with another (two wall switches required).
Use connection 2, as described in Figure 12, if there is no sepa- rate wall switch power wire for the light fixture.
NOTE: Wall switches not included.
3.Connect the wires as shown in Figure 12. To connect the wires, twist the bare metal leads together. Place a wire nut over the intertwined length of wire and twist clockwise until tight as.
© 2007 Hunter Fan Company |
