7
3.Assemble the upper switch housing to the mounting plate using the three screws and lockwashers which you removed from the mounting plate. Tighten the screws securely.
CAUTION: Make sure the upper switch housing is se- curely attached to the switch housing mounting plate. Fail- ure to properly attach and tighten all three housing assem- bly screws could result in the switch housing and light fix- ture falling.
attaching the lower switch housing
1.Connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly. See Fig- ure 17.
NOTE: Both plug connectors are polarized and will only fit to- gether one way. Make sure that both connectors are properly aligned before connecting them together. Incorrect connec- tion could cause improper operation and damage to the prod- uct.
Notch in | Fitter Cover |
Globe | Fitter |
Assembly |
|
Globe Assembly
Figure 18 - Installing the globe assembly
installing without the light fixture
1. | Install the upper switch housing as shown in the attaching |
| the upper switch housing section. |
2. | Disconnect the two single plug connectors in the lower switch |
| housing. Place the dummy terminals (in the sack parts) on the |
| end of each single plug connector. The female dummy termi- |
Lower Plug
Connector
Housing
Assembly
Screw
Upper Switch
Housing
Upper Plug
Connector
Lower
Switch
Housing
nal must be placed on the male plug connector and the male |
dummy terminal on the female plug connector. |
3. Remove the fitter assembly from the lower switch housing by |
removing the two screws inside of the fitter as shown in Figure |
19. |
Figure 17 - Connecting the plug connectors
2.Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the up- per switch housing with three
installing the light fixture
1.Install the included CFL bulb.
2.Align the notches in the globe assembly with the bumps on the fitter.
3.Twist the globe assembly clockwise until it locks in place.
4.Be sure that the holes in the fitter cover and globe assembly align as shown in Figure 18. If they do not, remove the globe assembly and begin with step 2 in a different position.
Fitter
Remove these screws
Figure 19 - Removing the fitter assembly
4.Install the lower switch housing as shown in the attaching the lower switch housing section.
5.Install the cap and plug button as shown in Figure 20.
Cap
Plug Button
Figure 20 - Installing the cap and plug button
© 2007 Hunter Fan Company |