8
operating your ceiling fan
1.Turn on electrical power to the fan.
2.The fan pull chain controls power to the fan. The pull chain has four settings in sequence: High, Medium, Low and Off.
•Pull the chain slowly to change settings.
•Release slowly to prevent the chain from recoiling into the blades.
•The chain uses a breakaway connector that separates if the chain is jerked. If this happens, simply reinsert the chain into the connector.
cleaning your ceiling fan
caring for finishes
For cleaning, a soft brush or
caring for blades
The painted and
troubleshooting
Problem: Nothing happens; fan does not move.
1.Turn power on, replace fuse, or reset breaker.
2.Loosen canopy, check all connections according to the wiring the fan section.
3.Check the plug connection in the switch housing.
4.Pull the pull chain to ensure it is on.
5.Remove the shipping bumpers.
Problem: Noisy operation.
1.Tighten the blade bracket screws until snug.
2.Tighten the blade screws until snug.
3.Check to see if the blade is cracked. If so, replace all the blades.
4.Change to an approved speed control.
5.Check and tighten the screws in the switch housing mounting plate and in the upper and lower switch hous- ing.
Problem: Excessive wobbling.
1.If your fan wobbles when operating, use the enclosed bal- ancing kit and instructions to balance the fan.
2.Tighten all blade and/or blade iron screws.
3.Turn power off, support fan very carefully, and check that the hanger ball is properly seated.
If you need parts or service assistance, please call
Hunter Fan Company
2500 Frisco Avenue
Memphis, Tennessee 38114
© 2007 Hunter Fan Company |