Hunter Fan 42027-01 manual Assembling and Hanging the Fan Low Profile Only, Steps, 10 Detail

3 • Assembling and Hanging the Fan (Low Profile Only)

You can assemble your fan for standard or angle mounting as shown in steps 3-1 – 3-6 on the previous page. For low profile mounting (ceilings less than 8 feet high), see steps 3-7 – 3-11 on this page.

3-7. Locate the washer that comes preassembled in the canopy. Remove the label and discard the washer and label. Locate the set screw preassembled in the adapter. Remove and discard the set screw. (Refer to images on previous page.)

3-8. Place the low profile washer from the parts sack into the canopy.

3-9. Place the canopy trim ring and canopy with washer on top of the fan assembly.

3-10. Align the screw holes in the washer with the holes in the adapter. Assemble securely with three #8-32 x 1/2” screws.

3-11. Raise the fan and place the hook on the hanger bracket through the round hole in the rim of the canopy.

WARNING: Fan may fall if not assembled as directed in these installation instructions.

Steps 3-8 – 3-10

Low Profile Washer

Adapter Canopy

Trim Ring

#8-32 x 1/2” Screw

Do not remove the protective wrap from the silhouette on the motor housing. You will remove it after the last step on page 13.

7

(Not Actual Size)

Step 3-10 (Detail) Low Profile Washer

Hook

Hanger

Bracket

Round

Hole

Step 3-11

42027-01 • 12/09/05 Hunter Fan Company