WARNING: Fan may fall if not assembled as directed in these installation instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angled Mounting:
3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. Feed the wires from the fan through the downrod.
3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to Step 3-7.
CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Profile Mounting:
Note: For low profile mounting, the downrod is replaced with the low profile washer.
3-4. Remove the set screw from the adapter.
3-5. Place the low profile washer into the canopy. Be sure the green ground wire is pointing up toward the ceiling.
3-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws.
3-7. Raise the fan and align the slots in the canopy with the tabs on the ceiling plate.
Ceiling | Step 3-7 |
Plate | |
Tabs | |
Downrod
Canopy
