Hunter Fan 42656-01 5 In sta lli ng the Ca nop y a nd Can opy Tri m R ing

42656-01•08/14/09•HunterFanCompany

5 • In sta lli ng the Ca nop y a nd Can opy Tri m R ing

WARNING: Failure to complete the following steps could cause the fan

to fall.

Note: It is recommended you use a magnetic tip screwdriver for the

following steps.

5-1.Rotatethehangerballsothetabinthecanopyis��secureinthe

hanger ball groove. Note: Your fan may have multiple tabs and

grooves that must be aligned.

5-2. Swing the fan up to align the canopy screw holes with the

mounting holes on the ceiling plate.

WARNING: e slots in the canopy must remain engaged while

swinging the canopy for alignment.

5-3. Holdingthecanopyupwiththescrewholesaligned,partially

install two canopy screws into the holes opposite the ceiling plate

tabs.

5-4. Partially install a canopy screw between the slots in the canopy.

When all the holes are properly aligned, securely tighten all three

canopy screws.

5-5. Verify that the tabs in the canopy are still in the grooves of the

hanger ball.

5-6.Alignthetabsonthetrimringoppositethegroovesinthehanger

ball.Usingbothhands,pushthecanopytrimringuptothetopof

the canopy. e canopy trim ring will snap and lock into place.

Note: Should you need to remove the trim ring, press ﬁrmly on

opposite sides of the trim ring directly above the groove in the

hanger ball. e tabs will ﬂex out releasing the canopy trim ring.

Step 5-1

Groove

Tab

Step 5-3

Canopy Screw

Canopy

Trim

Ring

Canopy

Step 5-2