WARNING: Fan may fall if not assembled as directed in these installation instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angle mounting:
3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. Feed the wires from the fan through the downrod.
3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers.
3-4. Align and engage the two tabs from the bottom of the canopy and the two grooves in the hanger ball. Skip to 3-9.
CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is not used.
3-5. Remove the set screw from the adapter.
3-6. Using a sharp pointed tool, pierce three holes in the rubber gasket where indicated by the holes in the housing.
3-7. Align the holes in the bottom of the canopy with the holes in the motor housing and gasket.
3-8. Install three low profile screws to secure the canopy to the motor housing.
Hanging the fan:
3-9. Raise the fan and place the hook on the ceiling plate through the round hole in the rim.
Downrod
Low Profile Screw