Hunter Fan 90057, 90056, 90055 Existing Construction - accessible only from below, Existing Fan

Existing Construction – accessible only from below

D11 EXISTING FAN

D12

E

Remove an existing fan and check to make sure the open-	Move the housing into position above the ceiling.
ing is large enough to accommodate the new motor hous-
ing (8”x 8.5”).

D13

Pull wires through strain relief.

D14

2

1

Attach existing ducting to duct connector. Tape joints.

If ducting does not fit securely,

an adapter may need to be purchased.

D15

E

Install the housing flush with the sheetrock and secure by

tightening the pre-loaded screws into the joist.

41719-01 3/29/2006

41719_EngS_3.29.06.indd 15

15

3/29/06 9:16:52 PM