NOTE: Some Hunter fans require a special adaptor plate between the switch housing and the light kit. This plate is pro- vided with those fans which need it. It should be installed as shown in Figure 5C. If the switch housing on your fan is
LIGHT KIT
ADAPTOR 
LIGHT KIT
FIGURE 5C
Step 7: Finish Fan Assembly
A. The ceiling plate has (3) mounting screw holes located on the side. Lift up the rubber cover and install (2)
Remove the fan from the ceiling plate hook. Make sure not to break any wire connections. The canopy has (2) mating slots and
(1) mating hole. See Figure 6.
RUBBER COVER
CEILING PLATE
MOUNTING SCREWS
MOUNTING HOLE
CANOPY
MOUNTING SLOTS (2)
B. Position (2) slots in canopy directly under and in line with
(2)mounting screws in ceiling plate. Lift fan until ceiling plate mounting screws are seated in bottom of slots in canopy. Rotate fan counterclockwise until both mounting screws drop into slot recesses. Tighten screws securely. Install third screw into mount- ing hole.
CAUTION: Failure to securely assemble the canopy screws could result in the fan falling.
NOTE: For the hanging fan configuration, rotate fan until groove in ball is positioned over tab in canopy. Make certain groove and tab are engaged before running fan. See Figure 7.
Failure to do this could result in the fan falling.
Step 8: Fan Blade Assembly, Installation, and Balancing
NOTE: Attach each blade with the central line (ridge) facing upward and flat side of blade facing downward. Correct installa- tion is with the ridge upwards towards the ceiling.
A. Attach wood blades to blade brackets using three screws for each blade. See Figure 8. If your blades have large holes you must first insert the rubber grommets into the holes. See Figure 8A.
NOTE: Grommets are usually assembled by hand. If you use a tool, make certain you do not damage the grommet or blade when inserting the grommets.
Next assemble the blade to the blade bracket. Make sure all screws are tight to prevent vibration or wobbling.
Even when the screws are tight, the blades may seem to be loose. This is normal when using grommets and will not be a problem.
RIDGE
BLADE
GROMMET
FIGURE 6
LEAD WIRES
CANOPY 
GROOVE IN BALL
PIPE NIPPLE
ROTATE BALL UNTIL GROOVE IN BALL
ENGAGES TAB IN CANOPY
FIGURE 7
FIGURE 8 | FIGURE 8A |
B. Remove the screws and rubber bumpers from the motor hub. Insert a mounting screw (provided) in hole in blade bracket. Use a screwdriver to hold in place. Align blade holes with mounting holes in hub by turning screw and readjusting blade bracket until screw mates with threaded hole in hub. Do not tighten until both screws have been put in blade bracket. Repeat for all blades. See Figure 9.
C. A blade balancing kit has been provided with your fan. Should the fan wobble in operation, you may use this kit to cor- rect the balance per the instructions supplied with the kit.
FORM NO. | - 3 - | ©1995 HUNTER FAN CO. TM |
