Drain
Valve

Drain Valve: The drain valve is located at the base of the air tank and is used to drain condensation at the end of each use.

Cooling System (not shown): This compressor

contains an advanced design cooling system. At the heart of this cooling system is an engineered

fan. It is perfectly normal for this fan to blow air

through the vent holes in large amounts. You know that the cooling system is working when air is being expelled.

Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.

Check Valve (not shown): When the air compressor is operating, the check valve is “open”, allowing compressed air to enter the air tank. When the air compressor reaches “cut-out” pressure, the check valve “closes”, allowing air pressure to remain inside the air tank.

Tool Storage: Grips and holds quick connect plug on tools and accessories in place for storage.

Tool Storage

Accessory Storage: Stores and protects accessories when not in use.

Accessory

Storage

How to Use Your Unit

How to Stop:

1.Set the On/Auto/Off switch to “OFF”.

Before Starting

Break-in Procedure

Serious damage may result if the following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

1.Make sure the On/Auto/Off switch is in the "OFF" position.

NOTE: Pull coupler back until it clicks to prevent air from escaping through the quick connect.

D29616

12- ENG

Page 12
Image 12
Husky D29616 manual How to Stop, Before Starting, Cooling System not shown This compressor, Tool Storage, Accessory Storage