532 42 14-48 Headlight Bezel Gray, Bulb

REPAIR PARTS

HANDLES

SNOW THROWER - MODEL NO. 1130SB-LS (96193002900), PRODUCT NO. 961 93 00-29

		3	KEY	PART
		3	NO.	NO.	DESCRIPTION
			NO.	NO.	DESCRIPTION
5	2		1	532 41 62-88 INTERLOCK SPRING
5			2	532 41 45-72 INTERLOCK CAM
			2	532 41 45-72 INTERLOCK CAM
			3	532 17 88-31 TORSION SPRING
	1		4	532 16 96-75	RETAINER
	1		5	817 06 04-10 SCREW 1/4−20 X .625
			6	532 42 12-52 INTERLOCK STOP
	6	01.08.007-B

		1	6
		1
			4
3
	8		5
		2
			4
7	5	KEY	PART	DESCRIPTION
		NO.	NO.	DESCRIPTION
		1	532 42 13-51 CONSOLE PANEL GRAY
		2	532 42 14-48 HEADLIGHT BEZEL GRAY
		3	532 17 86-66 HALOGEN HEADLIGHT
01.10.010-A		4	532 18 44-71 SHOULDER SCREW 10−24 X .625
01.10.010-A		5	532 17 52-62 SCREW 10−24 X 1.25
		5	532 17 52-62 SCREW 10−24 X 1.25
		6	532 41 77-60	GRIP SWITCH
		7	532 40 56-99 WIRE HARNESS
		8	532 40 16-20	BULB

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 31

Page 31

Image 31

Husqvarna 1130SB-LS owner manual 532 42 14-48 Headlight Bezel Gray, 532 17 86-66 Halogen Headlight, Grip Switch, Bulb

Contents

1130SB-LS Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Parts Packed Separately in Carton Install Traction Drive Control ROD See Figs Install Speed Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotater Head See Fig Install Auger Control ROD See Figs Check Tire Pressure Install Chute Deflector Remote Control See Figs Ignition KEY OperationKnow Your Snow Thrower Primer Recoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow Thrower To Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Throw Snow See Fig Before Starting the Engine Before Stopping To Start EngineIf Recoil Starter has Frozen Lubrication MaintenanceGeneral Recommendations Before Each USE Engine Cleaning Shear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute Deflector To Replace Belts See Fig Other Storage Troubleshooting Auger Housing / Impeller Assembly Repair Parts KEY Part Description Auger Ball Bearing Auger Assembly 30 RH Auger Assembly 30 LHSkid Plate 01.16.001-A 532 42 17-28 Shield Retainer Strap Control Panel / Discharge ChuteKnob Black POP Rivet Rotator Pivot Bracket 532 42 11-60 LEVER/CABLE Rotator Assembly GrayCable Assembly Gray Rotator Head Handles POP Rivet 1/8 01.05.006-A Repair Parts Bulb Grip Switch532 42 14-48 Headlight Bezel Gray 532 17 86-66 Halogen Headlight Drive HEX Shaft 532 19 84-74 Speed Selector Head AssemblyTrunnion Bearing Assembly 532 19 77-63 Drive Plate Weldment 532 19 95-09 Rubber Wheel Plate 532 40 61-09 Control Shaft AssemblyAssembly 532 18 00-82 Intermediate Gear Clik PIN Axle ShaftRoll PIN 3/16 Gear Axle Lobe CoverWheel Lobe Clutch Slide Bottom PAN Frame Pulley Chassis / Engine / PulleysImpeller Belt Wheels Retainer PIN Power Cord532 03 50-62 Safety Ignition KEY BAG of Parts DECAL, Husq DECAL, Husq 532 18 10-35 DECAL, DANGER, Deflector532 18 37-30 DECAL, Remote Deflector Service Notes Service Notes Warranty Statement

Husqvarna 1130SB-LS 532 42 14-48 Headlight Bezel Gray, 532 17 86-66 Halogen Headlight, Bulb

Models: 1130SB-LS

REPAIR PARTS

HANDLES

SNOW THROWER - MODEL NO. 1130SB-LS (96193002900), PRODUCT NO. 961 93 00-29

KEY

KEY

532 42 14-48 HEADLIGHT BEZEL GRAY

532 17 86-66 HALOGEN HEADLIGHT

GRIP SWITCH

BULB