10. CHANGING FUNCTIONS USING THE MEMORY SWITCHES
10-1. Memory switch table
The memory switch settings are applied immediately to all programs once the settings have been changed. However, memory switches marked with * are only applied after the power is turned on.
No. | Setting items | Setting range | Unit | Default |
|
|
|
|
|
00. | Cloth presser down operation when feed bracket is | OFF, ON | - | OFF |
| forward |
|
|
|
01. | Cloth presser stays down after sewing | OFF, ON | - | OFF |
|
|
|
|
|
02. | Number of home position start cycles (Note 1) | OFF, 1 - 9 | 1 | 1 |
|
|
|
|
|
03. | Cutting block ON time | 25 - 200 ms | 25 ms | 25 ms |
|
|
|
|
|
04. | Timer for checking raising of hammer | OFF (Determined | 50 ms | OFF |
| (Timer for determining if the cutting block has been | from number of slit |
|
|
| raised to a position where it will not touch the next | signals), |
|
|
| feed bracket to operate) | 200 - 500 ms |
|
|
|
|
|
| |
05. | Feed operation timing correction after hammer is | 0 - 150 ms | 25 ms | 0 |
| raised |
|
|
|
| (After checking that the hammer is raised, the timer |
|
|
|
| interval is added so that the hammer and feed |
|
|
|
| bracket do not touch.) |
|
|
|
06. | Test feeding deceleration speed | OFF, 1 - 4 | 1 | OFF |
|
|
|
|
|
07. | Increased amount of upper thread remaining | OFF, 1 - 3 | 1 | OFF |
|
|
|
|
|
08. | Stitch length display in automatic mode | OFF, ON | - | OFF |
|
|
|
|
|
09.* | Max. stitch length of L7 | 40 mm, 42 mm | 2 mm | 40 mm |
|
|
|
|
|
10. | Feed timing correction | 1 | 0 | |
|
|
|
|
|
11.* | Number of eyelet buttonholes when fly indexer is | OFF (Fly indexer is | 1 | 1 |
| used | not used),1 - 9 |
|
|
12.* | Cloth setting position when fly indexer is used | 1: Left setting | 1 | 1 |
|
| position |
|
|
|
| 2: Horizontal setting |
|
|
|
| position |
|
|
13. | Program number selected when buttonhole sensor | OFF, 1 - 9 | 1 | OFF |
| is ON when using the special lapel cutting device |
|
|
|
14. | Program number for operating the straight | OFF, 1 - 9 | 1 | OFF |
| buttonhole hammer regardless of eyelet shape |
|
|
|
| setting (parameter No. 01) and whether the |
|
|
|
| buttonhole sensor is ON or OFF (Note 2) |
|
|
|
(Note 1) If home position starting is not carried out for each piece of material, there is the danger that the feed bracket may become overloaded for some reason and come off, which will affect the next piece to be sewn. Accordingly it is recommended that you set home position starting to be carried out each time (setting "1").
(Note 2) If a program number has been set for memory switch No. 13, it will be ignored if a program number has been set for memory switch No. 14.
73
