3. INSTALLATION
3-12-4. Securing the cables
3132Q
3002Q
3003Q
3004Q
Note: Leave enough looseness in the cables so that they will not be pulled when the machine head is tilted back.
1.Pass the cable through the cable holder (1), and then secure the cable holder (1) to the underside of the work table with the screw.
2.Pass the air tube and the hand switch cable through the cable holder (2), and then secure the cable holder (2) to the underside of the work table with the screw.
3.Place the machine head cable together with the valve cable assembly and motor cable, pass them all through the cable holder (3), and then secure the cable holder (3) to the underside of the work table with the screw.
Insert the specification harness (1) into the control box connector (2).
Note: Check that the label number on the specification harness (1) matches the movable knife (R) (3), movable knife (L) (4), thread handler (5), work clamp (R) (6), work clamp (L)
(7)and movable knife driving cam (8) numbers before inserting the specification harness (1). (If a connector with an incorrect label number is connected, it may cause problems such as damage to the sewing machine or thread trimming errors.)
Specification | Label No. | Right/left work clamp No. | |
of harness | Right/left movable knife No. | ||
|
|
| Thread handler No. |
0 |
| ||
| L1 | 1 | 1 |
| L2 | 2 | 2 |
L3 | 3 | 3 | |
L4 | 4 | 4 | |
| L5 | 5 | 5 |
| L6 | 6 | 6 |
| L7 | 7 | 7 |
*There is 10 mm of difference in the knife installation positions between L1 - L4 and L5 - L7.
16
