Brother rh-918a manual Changing Functions Using, Replacing the knife, Memory switch table

9-5. Adjusting the clearance between the
looper and needle	58
9-6. Adjusting the needle guard	59
9-7. Adjusting the spreader mounting positions	59
9-8. Adjusting the spreader timing	60
9-9. Adjusting the needle racking width
(stitch width)	60
9-10.Changing the knife cutting length
(Replacing the hammer)	61
9-11.Adjusting the contact between the knife
and the hammer	62
9-12.Replacing the knife	63
9-13.Adjusting the cutting pressure	63
9-14.Adjusting the position of the work
clamp plate	64
9-15.Adjusting the cloth opening amount	65
9-16.Adjusting the trimming
of the upper thread	66
9-17. Adjusting the trimming
of the lower thread and gimp	66
9-18.Adjusting the gimp length after trimming
(-02, -52 specifications)	67
9-19.Lower thread presser
(-02, -52 specifications)	67
9-20.Auxiliary clamp arm
(-02, -52 specifications)	68
9-21.Adjusting the cloth feeding speed
(-52 specifications)	68
9-22.Adjusting the cloth feed bar home position
(-52 specifications)	69
9-23.Adjusting the indexer hole spacing
(-52 specifications)	70
9-24.Adjusting the position of limit switch L
(-52 specifications)	71
9-25.Adjusting the position of limit switch R
(-52 specifications)	71
10. CHANGING FUNCTIONS USING
THE MEMORY SWITCHES	72
10-1.Memory switch table	73
11. CHANGING FUNCTIONS USING
THE DIP SWITCHES	74
11-1. Panel DIP switches	74
11-2. Circuit board DIP switches	75
12. LIST OF ERROR CODES	77
13. TROUBLESHOOTING	80

RH-981A