Brother rh-918a manual Program setting method, Parameter table Taper bar

6. OPERATION

6-3. Program setting method

3051Q

1.Press the SELECT key (1) to change the mode to automatic, manual or test feed mode.

2.Press the and keys to select the program number (1 - 9) for the independent program to be changed.

Note: Program mode is not available if a cycle program has been selected.

3.Press the SELECT key (1). The program mode indicator (2) will illuminate.

*The parameter number "00" will appear in the program number display (3), and the parameter details will appear in the detail display (4).

4.Press the and keys to select the number of the parameter to be changed.

5.Press the and keys to change the parameter setting. (Refer to "Parameter table".)

*The flashing display indicates that the value has not yet been accepted.

6.Press the ENTER key (5) to accept the changed setting. (The display will then illuminate steadily.)

7.Repeat steps 4 to 6 to change other parameter settings.

8.Press the SELECT key (1) to change the mode to automatic mode.

*The program settings will be memorized.

6-3-1. Parameter table ( Taper bar )

The allowable setting range for some parameters may vary from the range specified, depending on the settings of other parameters.

No.	Setting items	Setting range	Unit	Default
00	Sewing speed	1,000 - 2,200 rpm	100	1,800
01	Eyelet pattern	1 - 6	1	2
02	Button hole length (*1)	-00: 5 - 50 mm	1	-00: 25 mm
		-01: 5 - 38 mm		-01: 25 mm
		-02 (L1): 14 - 18 mm		-02 (L1): 16 mm
		(L2): 18 - 22 mm		(L2): 20 mm
		(L3): 22 - 26 mm		(L3): 24 mm
		(L4): 26 - 30 mm		(L4): 28 mm
		(L5): 28 - 32 mm		(L5): 30 mm
		(L6): 32 - 36 mm		(L6): 34 mm
		(L7): 36 - 40 mm		(L7): 38 mm
03	Tacking length	0 - 20 mm	1	6

*1 The Button hole length setting value and the default value vary depending on the machine sub-class.

37

RH-981A