Brother rh-918a manual Connecting the connectors, 3023Q 3024Q 3025Q

3. INSTALLATION

3-17-5. Connecting the connectors

3023Q

3024Q

3025Q

1.Insert the 3-pin connectors [8], [9] and [10] of the valve harness into the solenoid valves of the valve unit (1) so that the label numbers match.

2.Insert the 15-pin connector (2) into the connector of the indexer cord (3).

3.Open the rear cover (4) of the control box.

4.Insert the connector (5) of the indexer cord (3) in the position shown in the illustration.

5.Secure the cord with the cord clamp.

6.Insert the two pins of limit switch (R) (6) and the two pins of limit switch (L) (7) into the 15-pin connector terminals with matching numbers.

7.Connect the three pins of the cylinder sensor (8) into the 15-pin connector so that the cable colors match the connector numbers as given in the table below.

*If the cable colors are red, white and black, refer

to the colors in brackets.

Note: First disconnect the connector before inserting the pins, and then after inserting the pins, re-connect the connector.

	Switch pin	Cable color	15-pin
	No.		Connector
Limit switch	7	White	7
(R) (6)	12	Black	12
Limit switch	10	White	10
(L) (7)	15	Black	15
Cylinder		Brown (Red)	4
		Black (White)	9
sensor (8)
		Blue (Black)	14

8. Secure the cable with the cable clamp (9).

RH-981A

22