MAINTENANCE
Cooling system
To keep the working temperature as low as possible the machine is equipped with a cooling system.
The cooling system consists of:
1Air intake on the starter.
2Air guide plate.
3Fins on the flywheel.
4Cooling fins on the cylinder.
5Cylinder cover (directs cold air over the cylinder).
5
4
3
2
1
Clean the cooling system with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the machine overheating which causes damage to the piston and cylinder.
”Air Injection” centrifugal cleaning
Centrifugal cleaning means the following: All air to the carburetor passes through the starter. Dirt and dust is pushed out by the cooling fan.
IMPORTANT! In order to maintain operation of the centrifugal cleaning system it must be regularly maintained. Clean the air intake to the starter, the fins on the flywheel, the space around the flywheel, inlet pipe and carburetor compartment.
Winter use
Running problems can occur when using the machine in the cold and snowy conditions caused by:
•Too low engine temperature.
•Icing of the air filter and carburetor. Special measures are therefore often required:
•Partly mask the air inlet on the starter to increase the working temperature of the engine.
Temperature -5°C (23°F) or colder:
For running the machine in cold weather or powder snow, a special cover is available, which is mounted on the starter housing. This reduces the intake of cold air and prevents large amounts of snow from being sucked in.
CAUTION! If the special winterising kit has been fitted or any measures have been taken to increase the temperature these changes must be reversed before the machine is used in normal temperature conditions. Otherwise there is a risk of overheating, resulting in severe damage to the engine.
Heated handles
(372XPG)
On models with the designation XPG/G, the front as well as the rear handle are equipped with electric heating coils. These are fed with electrical current from an integrated generator in the chain saw.
When the red mark on the switch is visible, the heating is on.
36 – English
