Mufﬂer, Chain catcher | Husqvarna 1151322-95 specification

MAINTENANCE

Chain catcher

Check that the chain catcher is not damaged and is ﬁrmly attached to the body of the chain saw.

Right hand guard

Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.

Vibration damping system

Regularly check the vibration damping units for cracks or deformation.

Make sure the vibration damping units are securely attached to the engine unit and handle unit.

Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

Mufﬂer

Never use a machine that has a faulty mufﬂer.

Regularly check that the mufﬂer is securely attached to the machine.

Some mufﬂers are equipped with a special spark arrestor screen. If your machine has this type of mufﬂer, you should clean the screen at least once a week. This is best done with a wire brush. A blocked screen will cause the engine to overheat and may lead to serious damage.

Note! The screen must be replaced if it is damaged. If the screen is blocked the machine will overheat and this will cause damage to the cylinder and piston. Never use a machine with a mufﬂer that is in poor condition. Never

32 – English

Image 32

Husqvarna 1151322-95 manual Mufﬂer, Chain catcher

Contents

365 372XP English KEY to Symbols Symbols on the machineSymbols in the operator’s manual You will ﬁnd the following labels on your chain saw Contents Introduction Dear customer What is WHAT? What is what on the chain saw? General Safety Precautions Before using a new chain saw Machine′s safety equipment Always use common sensePersonal protective equipment Chain brake and front hand guard General Safety Precautions Throttle lockout Chain catcherRight hand guard Vibration damping system Stop switch Cutting equipmentMufﬂer General rules Chain Cutting equipment designed to reduce kickbackBar Sharpening your chain and adjusting depth gauge setting General information on sharpening cutting teeth Tensioning the chain Checking chain lubrication Lubricating cutting equipmentFilling with chain oil Checking wear on cutting equipment Chain drive sprocketNeedle bearing lubrication Working with the chain AssemblyFitting the bar and chain Fuel Handling Fuel Fuel safety FuelingTransport and storage Long-term storage Starting and Stopping Starting and stoppingCold engine Warm engine Stopping Basic safety rules Working TechniquesBefore use General working instructions General rules Basic cutting technique Terms Tree felling technique LimbingLog is supported at one end. There is a high risk Safe distance Directional cuts Felling directionClearing the trunk and preparing your retreat Felling cut Freeing a tree that has fallen badly How to avoid kickbackWhat is kickback? Cutting the trunk into logs General MaintenanceCarburetor adjustment Correctly adjusted carburetor High speed jet HChecking brake band wear Checking the front hand guard Checking the inertia brake release Immediately Mufﬂer Tensioning the recoil spring StarterChanging a broken or worn starter cord Air ﬁlter Changing a broken recoil springFitting the starter Must always be replaced Adjustment of the oil pump When making adjustmentsSpark plug Lubricating the bar tip sprocket Air Injection centrifugal cleaning Temperature -5C 23F or colderCooling system Winter use Other countries Electrical carburetor heatingCanada Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenance Technical Data Technical data Saw chain ﬁling and ﬁle gauges Federal Emission Control Warranty Statement Your Warranty Rights and Obligations American Standard Safety Precautions Safety precautions for chain sawOther safety precautions Kickback safety precautionsPage 1151322-95